Firmware 3.0.2. open source
marcokitt2000 opened this issue · 3 comments
Hello Anycubic,
There is now 3.0.2. firmware based on marlin bugfix 2.1.x with input shaping and linair advance.
I hope you will release soon this firmware open resource.
By the way when adjust z offset can you set it on the screen 0.05mm step to 0.01 that will be a better way to fine tune z height.
I now there is a pause error (when used m600 for now disabled) some people say its the mainboard others software i think is software. for us pause or filament change or when filament sensor goes off z must goes 10-20 mm up than goes to the front left or right-hand insert filament but the screen must be updated to for that.
And can we have build in screen manual z height and 4 points and in the middle for height z offset. than a option auto level without cleaning nozzle and calibration module. That it goes bed levelling 25 points. An d a dark screen brightness of lcd auto screen off when touch it goes on etc.
many things to go on.
Thnx for the latest firmware but it can better.
Please Fix M600, it is a essential funtion for me
Yes please AnyCubic, release the new 3.0.2 software version's marlin source code!
pls opensource! need to enable host actions!