O5 status, but can't get internet to work
maxpain opened this issue · 1 comments
Hi. I have an Internet provider with Eltex OLT and Eltex NTU-RG-1402G-W ONU.
Settings of this ONU:
Interfaces:
What is the second interface for? It has VLAN ID 1001
. I also saw 3300 VLAN ID
in omci
packets.
I tried Alcatel Lucent G-010S-P, but when I managed to get O5 status, the stick was constantly rebooting until I disconnected the fiber optic cable, so I decided to try another module — ODI DFP-34X-2C2. I managed to get O5 status but couldn't configure the Internet connection properly.
As I understood correctly, VlanMuxId
from the interfaces page of the provider's ONU is VLAN ID, so I used it for my internet interface. IPoE
— not sure what it is. Isn't it just DHCP without any tunnels and authorization like PPPoE?
My first attempt was: Flash the latest SFU firmware (M110_sfp_ODI_220923.tar
) and configure the stick as a bridge with transparent VLAN mode. I configured my router with VLAN ID 10 and DHCP — didn't work. I also tried to configure the stick with PVID: 10 — no success.
The second attempt was: Flash the latest HGU firmware (M114_sfp_ODI_hybrid_221209.tar
) and configure the stick as a router:
Also, no success.
What I'm doing wrong?
Some ISPs require MAC Address Cloning to give an IP by IPoE (DHCP) Check the original veip0.1 MAC Address then configure MAC Address Cloning with original one and set VLAN ID 10 and DHCP.