Problem: Noise/Beep when using the Bus wire as power supply (Workaround)
Opened this issue · 0 comments
In Revision 1.3 sowie 1.4 tritt ein lautes piepgeräusch auf sofern man die a-Busleitung als Spannungsquelle verwendet.
Dieses wird höchstwahrscheinlich durch das Hochfrequente Schaltnetzteil verursacht.
Bei Spannungsversorgung über P-Leitung oder via externer Quelle tritt dieses Problem nicht auf.
--
In revisions 1.3 and 1.4, a loud beeping noise occurs if the a-bus line is used as a power source.
This is most likely caused by the high-frequency switching power supply.
This problem does not occur when the power is supplied via the P-line or via an external source.
Workaround
Bridge P
and TCS:Bus Wire
(the positive +24V one) using a 56Ω resistor.
This reduces the noise to a minimum, still present but not annoying and beeping anymore.