Flashed Cetus Pro now it won't connect to the PC

Question

Flashed Cetus Pro now it won't connect to the PC

drew-man opened this issue 3 years ago · 7 comments

I flashed my Cetus pro with Cetus_pro_1.1.2.bin. It said it was complete so I disconnected removed the connection from the pc. I then went to put a battery on it and noticed no lights from the drone. It did beep at me but Now when I try to attach it to the pc windows says the hardware malfunctioned.

For the device drive I get

Unknown USB Device (device Descriptor Request Failed)
Windows has stopped this device because it has reported problems. (Code 43)
A request for the USB device descriptor failed

I can get it into the boot loader to start, I get the white lights, but it won't connect to the PC.

Did I fry this somehow? Is there anything I can do on my end?

fpvntt commented 3 years ago

Same here

Answer 1 · 2022-02-08T02:12:17.000Z

Hi, drew-man.

"I can get it into the boot loader to start, I get the white lights, but it won't connect to the PC."
Does it can not reload the firmware into the FC board?
When you get the board into bootloader, did the PC also show below warnings:
"
Unknown USB Device (device Descriptor Request Failed)
Windows has stopped this device because it has reported problems. (Code 43)
A request for the USB device descriptor failed
"

Answer 2 · 2022-02-08T13:49:41.000Z

Hi wenzhicode,

I can not load any firmware to the FC board.

Yes, That is the message I get on the PC when I get the board into bootloader and connect it to the PC.

Answer 3 · 2022-02-10T14:03:27.000Z

Turns out this was my fault. When connecting the USB connector to the board I couldn't see that I didn't have all the pins inserted into the connector. I will close this out now.

Answer 4 · 2022-02-10T22:17:27.000Z

just one question as it turns out I have v1.2 of the pro. is there plans to add support for this version to the configurator?

Edit: Just to note I have updated the firm ware to v1.2.2 and it still gives a message that no configuration received.

Answer 5 · 2022-03-19T16:51:22.000Z

just one question as it turns out I have v1.2 of the pro. is there plans to add support for this version to the configurator?

Edit: Just to note I have updated the firm ware to v1.2.2 and it still gives a message that no configuration received.

same here

Answer 6 · 2022-05-31T18:05:19.000Z

I am going to close this issue as the main issue reported was resolved and there is another issue reporting the "No Configuration Received" Message.