Bouni/luxtronik

Parameters for used energy since update to V2.88.3

Opened this issue · 4 comments

rubatec commented

Hi,

after the software update to V2.88.3 (Novelan LD7) there were some changes in the displayed values in the web server. The old value ID_WEB_WMZ_Schwimmbad is not longer counted up (while SWT in is active).

Instead there is a value for the heating element (amount of heat) and additionally some values for the used (electrical) energy. See also attached picture.

Is there a possibility to get access to the used energy variables in home assistant?

Thank you in advance

Sebastian

Bildschirmfoto 2023-11-05 um 21 46 56
rubatec commented

Unknown_Parameter_1136 = eingesetzte_energie_heizung
Unknown_Parameter_1137 = eingesetzte_energie_warmwasser

overseer2k commented

Hi,
are you sure that these parameters correspond to "Eingesetzte Energie"?
I'm running V3.89.4 on my alpha innotec heatpump, but the parameters 1136 and 1337 just roughly match what the web interface and the heatpump itself reports.
Futhermore, 1136 changed rather often last night, but there was no reported change in the web-interface. More importantly, the heatpump did not run at all.

rubatec commented

Hi, sorry for the late reply.
Yes in my case the values of 1136 and 1137 are the same as the values in the web server and the ones in the heat pump

  • 😕1
overseer2k commented

Thanks for your reply.
A few weeks ago, I've updated to V3.90.1 and it looks like the parameter are now more or less in line with the web interface.