ESP32 CANViewer

A ESP32 based CAN interface for your webbrowser

Super basic webclient

Requirements

Libraries

Hardware

ESP32
3.3V CAN Transceiver e.g. SN65HVD230

Setup

Download the required libraries
Compile sketch and upload
Use the ESP32 Sketch Data Upload Plugin to upload the data folder

What should work?

Server

The ESP32 tries to connect to your specified WIFI network. If no connection is possible it will start an access point.
On port 80 a simple webserver is available that serves the index.html.
The communication works via websockets on port 1337.

The websockets accepts JSON strings.
Currently the following commands are implemented on the server side:

SEND: {"cmd":"SEND", "id":1, "dlc":4, "data":[4,5,6,7]}
creates a CAN packet with ID 0x1 and the four data bytes
SETFILTER: {"cmd":"SETFILTER", "id":8, "mask":2047}
sets the CAN acceptance filter to ID 0x8 and the MASK to 0x7FF (I don't know how to reset the filter so you need to reset the ESP in order to clear it)
SETSPEED: {"cmd":"SETSPEED", "speed":125000}
resets the CAN library and configures the desired speed (there are no plausibilty checks included from my side, use a valid speed)

The server broadcasts a STATUS message every second:
{"ts":1234,"type":"STATUS","baudrate":500000,"filterId":-1,"filterMask":-1}
ts: timestamp (Arduino millis)
type: message type = STATUS
baudrate: current baudrate
filterId: currently set filter id (-1 means no filter set)
filterMask: currently set filter mask (-1 means no filter set)

Whenever a CAN packet gets received a message gets broadcasted:
{"ts":1234,"type":PACKETTYPE,"dlc":LENGTH,"data":[1,2,3,4,5,6,7,8]}
ts: timestamp (Arduino millis)
type: message type

STD: Standard CAN Frame
EXT: Extended CAN Frame
RTR: Remote Transmission Request
ERTR: Extended Remote Transmission Request

dlc: Data Length Code = 1-8 Bytes
data: 0-8 Bytes of payload data, only in STD and EXT Frames

Client

The client is currently just a super simple first try. It just creates a HTML table with all received packets and is pretty ugly. In javascript there are more functions available than what the GUI represents:

setSpeed(speed)
e.g. setSpeed(125000); sets a baudrate of 125KBit/s
setFilter(id, mask)
e.g. setFilter(0x8, 0x7FF); sets the filter to only receive packets with id 0x8
sendPacket(id, dataArray)
e.g. sendPacket(0x8, [1,2,3,4,5]); sends a five byte CAN packet with id 0x8 and the content 1,2,3,4,5

Cellgalvano/ESP32_CANViewer