Teku documentation shows an option that may not be available for validator-client

Question

Teku documentation shows an option that may not be available for validator-client

gethwethreth opened this issue 2 years ago · 2 comments

Visit the below link and you will see a section for initial-state which is not even a valid option for validator-client

https://docs.teku.consensys.net/en/latest/Reference/CLI/Subcommands/Validator-Client/

teku validator-client --help in CLI does not show initial-state

Answer 1 · 2022-08-18T19:07:17.000Z

Hi @gethwethreth, `initial-state` shows up just under `h, --help` when using `teku validator-client --help`. I've attached the screen shot here. Please let me know if you need any additional help. Thanks!

Answer 2 · 2022-08-19T04:05:21.000Z

Going to reopen this one. I'm not sure what version of Teku you're using but --initial-state isn't listed in help for the latest version of teku. I think it was mistakenly present in earlier versions though it was ignored. If we have --eth1-deposit-contract-address listed we should remove it too as it falls into the same category.