All Zero Bed Temp Crashes K1C
Opened this issue · 0 comments
I'm not sure if this problem is in the slicer (Creality Print) or if it's in the firmware of the K1C, but I've annoyingly reproduced this more times that I would like to admit. I was trying to setup a material to have no bed temp (cold bed). However, if you set all bed temps to 0 (zero) and send that to the printer, it freezes after the cleaning nozzle phase.
On my K1C, I cannot stop the job, and I loose network connectivity until I power off, wait for a few minutes, and then power back on. In most cases, I also have to reboot my router or the device does not reconnect to the network properly. I know that all sounds strange, and sounds like it should not be related, but I've done this about 10 times before I realized that it was the Zero bed temp settings in Creality Print that is causing the problem.