/arduino-uno-5LED-loop

A Sketchbook based on a YouTube tutorial, lights up and loops 5 LED's in sequence.

Primary LanguageC++Creative Commons Zero v1.0 UniversalCC0-1.0

arduino-uno-5LED-loop

Description:

A Sketchbook based on a YouTube tutorial, lights up and loops 5 LEDs in sequence.

Requirements:

  • Arduino Uno
  • USB Cable
  • Arduino IDE
  • Some C++ knowledge (If you want to modify or hack this)
  • 5 x 200Ω Resistors
  • 5 x Green Jumper Cables
  • 1 x Breadboard
  • 1 x Black Jumper Cable (Ground)
  • 5 x LED's (For this I used: Green, Red, Yellow, Blue + One RGB Diode)

Instructions:

  • Open the .ido file in your Arduino IDE, Verify and then Upload it.
  • Press Reset if required to clear it and run the new code.
  • Enjoy your blinking colorful LED's! :)

Pin Layout:

  • LED1 -> Board Pin 13
  • LED2 -> Board Pin 12
  • LED3 -> Board Pin 11
  • LED4 -> Board Pin 10
  • LED5 -> Board Pin 9

Original YouTube Video: /watch?v=e1FVSpkw6q4