[Bug]:
AcrimoniousMirth opened this issue · 1 comments
AcrimoniousMirth commented
Duet Forum Discussion Thread
https://forum.duet3d.com/topic/25253/odd-javascript-error-causing-connection-failure
Which Duet products are you using?
- Duet2-Wifi
- Duet2-Ethernet
- Duet Expansion Breakout Board
- Duex2
- Duex5
- Duet2-Maestro
- Maestro Dual Driver Expansion
- Duet3-6HC
- Duet3-3HC
- Duet3-1XD
- Duet3-1LC
- Duet3-Tool Distribution Board
- Duet3-Mini5+
- Duet3-Mini2+
- Raspberry Pi or other SBC
- SmartEffector
- Magnetic Filament Sensor
- Laser Filament Sensor
- PT100 Daughterboard
- Thermocouple Daughterboard
- PanelDue
- Other
- None
Firmware Version
RRF 3.x (can't connect)
Duet Web Control Version
Can't see, but new release
Are you using a Single Board Computer (RaspberryPi) with your Duet?
- Yes I use a SBC.
- No I do not use a SBC.
Please upload the results of sending M122 in the gcode console.
Can't connectPlease upload the content of your config.g file.
Can't connectPlease upload the content of any other releveant macro files.
Can't connectDetails specific to your printer.
Voron 2.4 350
Links to additional info.
No response
What happened?
Can't connect to printer due to fatal error as follows:
A JavaScript error has occurred so the web interface has closed the connection to your board. It is recommended to reload the web interface now. If this happens again, please contact the author and share this error message:
Version: 1.22.6
Message: TypeError: undefined is not an object (evaluating 'lastStatusResponse.temps.current[heater].toFixed')
URL: http://192.168.0.74/js/dwc.js
Line: 4468:74
Error object: {}
This was not an issue previous boots. All that has changed is plugging in my printer bed. Removing doesn't make a difference (as predicted).
AcrimoniousMirth commented
Apparently this version of DWC is ancient. I'm not sure how I ended up with ancient DWC on a RRF3.x set up a few months back but I did.
Closing now.