Support for XC7 Elite
Closed this issue · 8 comments
I recently added an XC7 Elite to my system. This uses the link system for both addressable RGB lights as well as a temperature sensor for the cold plate. I would like to be able to control the RGB lights via Signal RGB and get the temp sensor to show up in Fan Control.
How would I go about doing the USB captures required to get support for this?
I'd be happy to beta-test any changes you have for this after providing the capture and I can also maybe contribute some code if you point me to the docs for adding a new link component.
Hi @berkona, I just added USB packet capture instructions to the wiki. Let me know if you need any assistance. Thanks!
@berkona Just checking if you will be able to provide a packet capture using the instructions above. Thanks!
@EvanMulawski sorry for the delay. I was caught up in some other things. Attached is the pcap that I believe is captured correctly: xc7-elite.zip
0-10 seconds is idle, then iCue was started around 10 seconds and left without any input until 70 seconds.
Post 70 seconds I changed some of the light-related settings.
First set all LEDs to white then to random other colors then set a few individual LEDS to a color then two non-contiguous strips to the same color. Hopefully this is enough to work with.
Let me know if I need to capture different settings or anything else to do with the capture.
System consists of a single iCue Link hub with 3 120mm QX fans in linked in series to the port on one side. The port on the other side is connected directly to the XC7 Elite
@berkona Please try the attached build (follow the typical installation process). You should see the XC7's temperature sensor.
Yep I can now see the temp sensor. Thanks!
Completed in v1.6.0-beta.2