Unable to read tmc uart 'stepper_z' register IFCNT Once the underlying issue is corrected, use the "FIRMWARE_RESTART" command to reset the firmware, reload the config, and restart the host software. Printer is shutdown
Opened this issue · 0 comments
dkuchay commented
Voron 2.4, followed wiring guide for 2.4 R2 and added cabinet sb_can_th and usb adapter. Have jumpers under drivers set as exampled. support@fystec.com email address returns emails as undeliverable. Not able to figure out with instructions offered. The printer starts up will and interface loads. Error in subject line comes as soon as I press home button or try to ring a stepper. I have not tried all possibilities. I have a spider 2.3 with v3.0 stepper drivers.