GridSpace/grid-apps

CNC - Outline - Wide Cutout - Wrong Order

Closed this issue · 1 comments

Monberg75 commented

I tested the Wide Cutout, which is very usefull using a compression or downcut to be able to clean the cutting path. Also to make a finishing pass.

  1. The wide cutout is going the wrong order, It cuts from inside-out, and not outside-in. (Compared to other programs)
  2. Outside-in toolpath would also make it possible to make a finishing pass. especially if you make it possible to only run that pass at the final depth, making a nice and smooth finish removing eventual tool marks from tool deflection and so on. And maybe a repeating finishing pass to make it run an extra round and clean up the outer edge an extra time.
bakedPotatoLord commented

@Monberg75 is #362 what you had in mind?