InES-HPMM/FPD-LinkIII_ds90ub95x

Video0

shahbazaly opened this issue · 5 comments

Dear Sir,
I have got the deserializer and serializer made from a manufacturer in Germany. I am currently trying to get images through these on the the raspberrypi4. I can not seem to get the video0. I do get it when I connect the camera directly to the raspberrypi4. I have used the modprobe command aswell but it does not do anything. In the raspberrypi configuration I have not switched on any other interface. The leds don't blink either. I cant seem to understand the pass and lock leds functionalities.
Do you think there could be a problem in the hardware that I got from the manufacturer? some soldering issue? I really need to get this working. Need your assistance. Thank you.
I have attached error images and my setup.

20210107_132030
20210108_130747

On the picture of your setup the jumpers for the power supply are missing.

fpdlink2raspi PCB

And it seems that you have an error in the device-tree entry for ds09ub954. Can you post you device tree entry for ds90ub954?

Thank you for the response. I guess I am missing jumpwire. I have attached a picture can you please confirm if its the same one? Thank you.
Screenshot from 2021-01-08 17-17-56

I have error in the device-tree because I did not follow the steps further. I stopped after the video0 was not found. I do not have the driver installed in my linux yet. Thank you.

Thank you for the response. I guess I am missing jumpwire. I have attached a picture can you please confirm if its the same one? Thank you.
Screenshot from 2021-01-08 17-17-56

Looks good. As long as the pitch is the same as the header you should be good.