original mcu review
Opened this issue · 3 comments
wassfila commented
Reviewer : Raspi Team : Seth K
here are a couple easy steps that can make it easier to read.
First, I'd recommend using SOME net labels on page
- This would reduce the wiring clutter, and make the more important signals stand out.
- I would recommend adding expanding each circuit block so the circuits have more room to "breathe", and adding a text label under each block to indicate what they are/do.
Vincent-Stragier commented
82af7b3, adds comments to describe the function of most of the blocks.
wassfila commented
Feedback from team meeting review notes from @Informaticore
Meeting Notes:
Schematic review to da max
- freeze schematics after last change for regulators
- create ticket and reviews/findings from everybody there
- https://github.com/Informaticore/SuperPower/issues/39
- check requirements against the current schematics if they are met
Components annotation for BOM
- use same unit for components (100nF vs. 0.1uF)
- deciding for footprints
- Resistor: 0603
- avoid BGA
- capacitor X7R rating
- <10uF 0603
- '>10uF 0805
- wisley choose inductors
- set the foot prints
- swap components by multible different values to reduce component number
- one person should do that cleanup/setting
ToDo:
- put LED indicator for Power on VIN on the charger sheet
wassfila commented
- check again if the +5V reg should not get a Mosfet instead of driving the Enable pin
uA current won tbd.
Edit: The MCU regulator should be switched as well.