Windows batch file wont run
Opened this issue · 4 comments
GoogleCodeExporter commented
I followed all the steps and ran the windows batch file. My output was this:
Abracadabra!
C:\Users\adam\Downloads\UnoJoyWin-15May2012\UnoJoyWin\ATmega8u2Code\HexFiles>bat
chisp -device at90usb82 -hardware usb -operation erase f memory flash blankcheck
loadbuffer "UnoJoy.hex" program verify start reset 1024
Running batchisp 1.2.5 on Mon Oct 15 17:26:20 2012
AT90USB82 - USB - USB/DFU
Device selection....................... PASS
Hardware selection..................... PASS
Opening port........................... AtLibUsbDfu: 3EB 2FF7 no device present.
FAIL Could not open USB device.
ISP done.
-1
The firmware was NOT loaded...
Did you install the Atmel FLIP program? - http://www.atmel.com/tools/FLIP.aspx -
Is the Arduino plugged in?
Is is it in 'Arduino UNO DFU' mode?
Press any key to exit..
The arduino is plugged in and in DFU mode although it shows as the ATmega16U2
not the arduino DFU mode under system devices. Any solutions?
Original issue reported on code.google.com by ccoreg...@gmail.com
on 15 Oct 2012 at 11:37
GoogleCodeExporter commented
Hi there - Did you install the Atmel Flip program? What OS are you running? Is
it the 32 or 64 bit version? If it's showing up as the ATmega16U2, that's what
it should show up as in DFU mode.
Original comment by alan.chatham@gmail.com
on 17 Oct 2012 at 8:31
GoogleCodeExporter commented
Ive encountered this...
Im assuming your trying this on the "UNO". If you are having problems getting
the Arduino board to show as being in DFU mode then it could be that you are
using an "R1" version of the "UNO". flip the board over and if you dont see
"R2" or "R3" Then its a Revision 1 board and requires an extra step to place it
in "DFU" mode.
Go to this site:
https://www.virtuabotix.com/?p=673
half way down under the heading "For version One only" is possibly all you need
to sort this issue.
Original comment by matiuteh...@hotmail.com
on 4 Jan 2013 at 7:02
GoogleCodeExporter commented
I have the same problem with REV 3.
What can I do ?
Original comment by claude.e...@gmail.com
on 29 May 2014 at 11:54
GoogleCodeExporter commented
Plus I'm unable to go back into Arduino mode.
The batch says : "Atlibusbdfu : 3 EB 2FF7" no device present FAIL couldnot open
sb device.
I can't use my arduino anymore for now.
Original comment by claude.e...@gmail.com
on 29 May 2014 at 11:57