Not able to connect via the browser

Question

Not able to connect via the browser

osastar opened this issue 4 years ago · 15 comments

Hello all,

I've followed the steps and installed the Remote Control but i'm left with a problem.

Yesterday, I was able to go on the remote control interface but now it just doesn't work. I haven't changed anything. When i surf to the IP:8080/remote.html it says that the page isn't available.

i've set the address to 0.0.0.0 and left the IPwhitelist Empty []. Can someone please help me? this is for a school project :) thanks in advance

osastar commented 4 years ago

RPi

Answer 1 · 2021-05-17T18:54:47.000Z

I just found out that it only works when i'm using a wired connection on my laptop, On wifi it still doesn't work

Answer 2 · 2021-05-17T18:56:23.000Z

Hey! Did you check the IP of the mirror? Maybe it changed, and now you're trying to access to an unknown PC.
Can you access in your mirror itself using localhost? The console shows anything or just normal log?

Answer 3 · 2021-05-17T18:58:40.000Z

The IP of the mirror is still the same. I just found out that it only works when i'm using a wired connection on my laptop, On wifi it still doesn't work

Answer 4 · 2021-05-17T19:02:47.000Z

You're running it in a RPi or another OS?

Answer 5 · 2021-05-17T19:04:11.000Z

i also can't access the UI website through my phone, only a wired connection is able to surf on the website

Answer 6 · 2021-05-17T19:07:14.000Z

You could try opening ports of your router, that's probably causing the issue.

Answer 7 · 2021-05-17T19:07:51.000Z

the 8080 port?

Answer 8 · 2021-05-17T19:10:01.000Z

Yep, that's the one by default. If you are unable to access the Remote Control, it'll show a warning message. If you're not seeing anything like that, it's probably because you can't even reach the mirror.

Answer 9 · 2021-05-17T19:11:55.000Z

i should open it specifically for the ip of the Pi right?

Answer 10 · 2021-05-17T19:20:55.000Z

You said that only wired connections can access the mirror, right? Routers sometimes have an isolation option, I don't remember if it's just for wifi or also for wired. But check the router's settings and disable that option if you have it.

Answer 11 · 2021-05-19T19:58:30.000Z

I am facing the same issue... I tried all the above solutions.. Nothing seems to work... Anything that I ma missing here?

Answer 12 · 2021-05-19T22:39:53.000Z

@websterjazz Can you access via eth but not via wifi, right? Did you reload MM when doing those changes? Is there anything showing up in the log?

Answer 13 · 2021-06-01T22:05:31.000Z

@ezeholz it's working fine now.. thanks for your help!

Answer 14 · 2021-06-01T23:21:19.000Z

Glad to help!
I'm gonna close this issue now, but feel free to open another one.
Cheers!