OSD doesnt fit on the screen
Opened this issue · 1 comments
GoogleCodeExporter commented
What steps will reproduce the problem?
1.Connected to APM1 and Arducam OSD tool
2.Foxtech M800 8" monitor, Jdrones miniOSD
3.Same result connected via FTDI cable or via APM connection
What is the expected output? What do you see instead?
I expect the whole display fits the screen. The bottom three grid lines don't
show and top grid line is half off the screen. Width is displaying ok
What version of the product are you using? On what operating system?
v2.0 on Win7
Please provide any additional information below.
I tried to adjust the screen up and down and ratio, but i still don't get the
full display showing.
Original issue reported on code.google.com by jrcam...@gmail.com on 1 May 2013 at 4:26
GoogleCodeExporter commented
Your camera resolution is too small, you need a higher resolution camera. This
system I believe is optimised for 576p not 480p. Please try searching for forum
threads on this problem, I'm sure you will find the answer this way.
Hope this helps.
Original comment by doozer.s...@gmail.com on 12 May 2013 at 11:55