New APM modes not displaying on OSD
Opened this issue · 2 comments
GoogleCodeExporter commented
What steps will reproduce the problem?
1.Load the latest arduplane firmware
2.Enable acro mode, and cruise mode as selectable modes
3.switch to one of these modes and the osd will simply keep displaying the
previous mode.
What is the expected output? What do you see instead?
expected output is the correct mode should be displayed. Previous mode stays on
the screen despite the mode switch.
What version of the product are you using? On what operating system?
APM 2.74 mavlink osd 2.0
Please provide any additional information below.
Original issue reported on code.google.com by JohnnyFa...@gmail.com on 18 Sep 2013 at 8:47
GoogleCodeExporter commented
Sir is your MinimOSD v2.0 or v1.1?
Original comment by vkumar.a...@gmail.com on 27 Sep 2013 at 3:50
GoogleCodeExporter commented
V 1.1
Original comment by JohnnyFa...@gmail.com on 27 Sep 2013 at 3:58