Add Sencon state messages
tukusejssirs opened this issue · 0 comments
tukusejssirs commented
These are the possible codes for state
:
0
:run mode
/execution active
;1
:ready to run
/execution ready
;2
:not used
;3
:faulted
/execution interrupted
.
And the fault and warning message would each be the same as the “90-series” display message number.
The list of messages that are triggered by the ELTP panel processor to be displayed by the alphanumeric HMI.
eltp.txt
(renamed from eltp.msg
to eltp.txt
, as GitHub does not allow uploading unknown file extensions) can be opened with the editor program PCED40
or viewed somewhat with a text editor. It contains the list off messages
So, for example if the processor is triggering message “FAULT REFLECTED LIGHT L1” then it will show 120.