Use with 4.2.2 board
Closed this issue · 1 comments
Hi Lee,
What would need to be changed to use this package with a 4.2.2 board? Thanks!
I have an Ender 3 V2 running the stock 4.2.2 board, with a CRTouch and Sprite Extruder.
I was able to install these configuration files just now (with a few features disabled such as KAMP...for now) and can confirm it's looking good so far, I don't actually see any obvious differences between the instructions for 4.2.2 and 4.2.7.
Klipper has successfully connected to my printer and it's showing the current temperatures. Next up I need to run some calibrations, then see if I can get a print going.
Edit: I take that back, as soon as I tried to home the bed nothing happened. Turns out the pins on 4.2.2 are different, as per #8
I copied over the step_pin and dir_pin settings from here and that fixed it: https://github.com/Klipper3d/klipper/blob/master/config/printer-creality-ender3-v2-2020.cfg