Zones configuration Help

[zbuh]

Finally I installed the system, half year later :)
Using Waveshare POE and running as HA add-on.

My Rehau setup is with 3 floors, each one with its own rehau panel (valves controller), the main panel is on basement:
-1 (basement) is 1 heating area
0 (main floor) is 2 heating areas
1 (bedrooms) is 3 heating areas

My first difficulty is to properly configure the Integration in HA, I need to input the areas names (comma separated), but with which order?

I tried one random order, to after try to identify the correct one, and set it up again with the correct order.

But after doing this first setup, only 3 areas are returning information (Humidity), after putting the preset in Normal, only then I was able to adjust temp. thermostat.

But the other 3 areas, never had any information. After playing with thermostat, I was able to identify the 3 missing areas.
They are the areas from bedroom (1st floor).

Have you any idea of what maybe the issue here?

Can I debug it some way?

Thanks!

[zbuh]

with the information here (MatteoManzoni/rehau-neasmart2.0-integration-ha#3), I was able to check that my other zones were also non consecutive.
I needed to create "fake" zones (names) to reach the real ones.
I think we can improve the initial config, by specifying the index and name, this will avoid generating dummy devices in HA