Mermouy/flowblade

unable to use transitions

Closed this issue · 3 comments

GoogleCodeExporter commented 
What steps will reproduce the problem?
1. select two successive clips on the timeline
2. right or left-click on transition/fade button
3. you can choose a transition and the number of frames, if available wipe 
pattern or dip color and encoding, but not the clip handles (wonder what it is 
?), validate
4. a warning box appears, complaining that "TO clip handle is too short"


What is the expected output? What do you see instead?
I would like to be advised of the way to set the parameters for "clip handles", 
but I don't see any.


What version of the product are you using? On what operating system?
0.16 on Ubuntu 14.04 64 bits

Please provide any additional information below.

Original issue reported on code.google.com by erikmar...@hotmail.com on 25 Dec 2014 at 8:40

Attachments:

GoogleCodeExporter commented 
I just noticed that depending on the couple of clips selected, it could 
sometimes be working or not, and the "FROM clip handle" can be too short as 
well.

Original comment by erikmar...@hotmail.com on 25 Dec 2014 at 8:52

GoogleCodeExporter commented 
[deleted comment]
GoogleCodeExporter commented 
The problem is exactly what dialog is telling you: you do not have material 
("handle")available to do the transition.

Try this if that helps you understand the problem.

1) Put two full clips on timeline
2) Try to do transition between them
3) You get the message

end then do this:

1) Put two full clips on timeline
2) Cut both clips in half
3) Remove two _center_ clips
2) Try to do transition between two remaining clips
3) Now it works because you have material to do the transition

Original comment by janne.li...@gmail.com on 4 Feb 2015 at 8:26

  • Changed state: Invalid