MirageC79/HevORT

ZR2.6 Motor Mounts - Rear facing M6 attaching to 3030 are shifted outwards by 1.705mm

Closed this issue · 1 comments

MirageC79 commented

Problem:

I have been chasing the root cause of this shift in the CADs and I am going all the way back to the ZR2.8 which was the basis for these motor mounts and the issue is also present.
I am surprised that I have not came across this issues when assembling my printer and that no one reported this before today. Good catch @Steffen12345 !
This situation is present on both FrontLeft and FrontRight ZR2.6 Motor mounts. Rear unit is not affected.

Corrective action plan

I will be correcting the files today and re-issue STLs with corrected dimensions. I will post the update here and on FB.

Meanwhile (Recommendation)

If you already printed those parts:
I recommend that you're-drill the holes a bit bigger to facilitate the installation. Make sure that both reference surfaces are sitting flush to the 3030 extrusions during installation.

If your printer is assembled (As it is the case for mine):
The impact of this shift is very limited on the overall assembly. Especially with WobbleX. I recommend you leave as is.

image

MirageC79 commented

Issue corrected.
image