IPV6 Broken on pfsense 2.5.0
andmpel opened this issue · 3 comments
andmpel commented
Since upgrading to pfsense 2.5.0 I can't get an IPV6 address.
No config changes have been made. I've rebooted all equipment, verified settings. No luck
logs
2021-02-20 01:29:36 :: [pfatt.sh] :: pfSense + AT&T U-verse Residential Gateway for true bridge mode
2021-02-20 01:29:36 :: [pfatt.sh] :: Configuration:
2021-02-20 01:29:36 :: [pfatt.sh] :: ONT_IF: igb0
2021-02-20 01:29:36 :: [pfatt.sh] :: RG_IF: igb1
2021-02-20 01:29:36 :: [pfatt.sh] :: RG_ETHER_ADDR: ec:a9:40:d7:0f:71
2021-02-20 01:29:36 :: [pfatt.sh] :: attaching interfaces to ng_ether... OK!
2021-02-20 01:29:36 :: [pfatt.sh] :: building netgraph nodes...
2021-02-20 01:29:36 :: [pfatt.sh] :: creating ng_one2many... OK!
2021-02-20 01:29:36 :: [pfatt.sh] :: creating vlan node and interface... OK!
2021-02-20 01:29:36 :: [pfatt.sh] :: defining etf for igb0 (ONT)... OK!
2021-02-20 01:29:36 :: [pfatt.sh] :: defining etf for igb1 (RG)... OK!
2021-02-20 01:29:36 :: [pfatt.sh] :: bridging etf for igb0 <-> igb1... OK!
2021-02-20 01:29:36 :: [pfatt.sh] :: defining filters for EAP traffic... OK!
2021-02-20 01:29:36 :: [pfatt.sh] :: enabling one2many links... OK!
2021-02-20 01:29:36 :: [pfatt.sh] :: removing waneapfilter:nomatch hook... OK!
2021-02-20 01:29:36 :: [pfatt.sh] :: enabling igb1 interface... OK!
2021-02-20 01:29:36 :: [pfatt.sh] :: enabling igb0 interface... OK!
2021-02-20 01:29:37 :: [pfatt.sh] :: enabling promiscuous mode on igb1... OK!
2021-02-20 01:29:37 :: [pfatt.sh] :: enabling promiscuous mode on igb0... OK!
2021-02-20 01:29:37 :: [pfatt.sh] :: ngeth0 should now be available to configure as your pfSense WAN
2021-02-20 01:29:37 :: [pfatt.sh] :: done!
WAN_DHCPV says "pending" & "Unknown"
andmpel commented
Disregard it seems just to be an issue on Windows Machine
andmpel commented
I didn't have ipv6 enabled in Windows 10 my apologies