OctoPrint/OctoPrint-Slic3r

Accessing config bundles

theDrsh opened this issue · 2 comments

theDrsh commented

Within Prusa slic3r there is a config bundle, which holds settings which allow you to choose layer height, and material, on the fly. It would be nice to have the same interface within the octoprint slic3r.

eyal0 commented

Have you tried OctoPrint-Slicer? I think that it will do what you want.

eyal0 commented

Too long without a response. I'm closing this. Re-open if you need a better solution.