can't post a request, this is not an issue but a request

Question

cnlson opened this issue 7 years ago · 4 comments

is there any way to make this pull slic3r prusa edition?

Answer 1 · 2017-12-26T14:36:32.000Z

Did you try the instructions?

Answer 2 · 2017-12-26T17:53:17.000Z

I'm looking to put a different slic3r, the prusa edition that has a different git than the standard slic3r

On Dec 26, 2017 8:36 AM, "Eyal - ***@***.***" ***@***.***> wrote: Did you try the instructions? https://github.com/OctoPrint/OctoPrint-Slic3r/wiki/How-to- install-Slic3r-on-RPi — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#27 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/ABYA61vOKS8gf8BW1pf2DIu0RdqJSwCjks5tEQRwgaJpZM4RJ9YF> .

Answer 3 · 2017-12-27T08:08:42.000Z

I understand. In the instructions, it explains how to put the prusa edition. Did you try that?

Answer 4 · 2018-02-28T14:52:40.000Z

It's been too long without an answer. I'm closing this. Re-open if you're still having trouble.