Loading a slic3r config
Aphris-Karu opened this issue · 1 comments
Setup:
Raspberry Pi 3 B+
Slic3r 1.3.0
Octoprint
OctoPrint-Slic3r
OctoPrint-Slicer (for doing the slicing)
Issue: Some config data does not appear to be loaded.
Description:
I first started by exporting my config from slic3r and importing it into the plugin. My start G-Code contains " start_gcode = G1 Z5 F5000 ; lift nozzle\nM420 S1\nG29 L0 ; Load mesh bed level\nG28 ; home all axes" However, I am not seeing the "Start G-code" when I do the slice (meaning it is not in the output of the slice)
The start G-Code also does not show up when trying to view it in the OctoPrint-Slicer plugin, so not sure which of the two plugins the issue is in.
Any help would be appreciated.
Sorry it was a version mismatch between my desktop slic3r and the slic3r on the raspberry pi.