Need help wiring PGM to a zone to trigger alarm from homeassistant
cdaguerre opened this issue · 1 comments
Alarm system
Magellan MG5050 over IP150
Environment
HomeAssistant on RPI
Git branch
dev, 3.2.1
Question
Hi I installed the PAI interface in HomeAssistant and everything works fine. This integration is impressive!!
I'm trying to trigger the alarm from assistant because I have additional Ubiquiti Sensors and Cameras.
I have 2 PGMs showing up (auto-discovered) and believe they don't do anything.
Apparently the solution would be to have a PGM trigger the alarm, but I have no clue as to what to do ;)
I found this comment from @yozik04, but I have no idea how to wire my zone to the PGM.
Fully unsupported. Use PGM wired to a zone to trigger alarms.
Originally posted by @yozik04 in #278 (comment)
Could you point me in the right direction?
I attached a photo of the Magellan...
I just bought this house with this alarm system and I don't know the installer pin-code (which is not 0000).
