Pioreactor/hardware

v0.2 issues

Closed this issue · 0 comments

CamDavidsonPilon commented
  • adc channel 2 (the version) is not set?
  • led driver aren't working (op-amp footprint problem)
  • I2c still detects channel 47 - no device on 47
  • Getting less power out of PWM. When using the heating (5 ohm resistive heating), on the old board, I was measuring output of ~0.665 A, on the new board, I was measuring ~0.470 A and ~0.448 A (comparing both new HATs). The latter two are too low for applications.