cloning keyfob 13.56 MHz
JOJOLEE1981 opened this issue · 4 comments
I got an error message as following when I tried to clone the keyfob 13.56 MHz
[usb] pm3 --> hf iclass dump --ki 0
[+] Using AA1 (debit) key[0] AE A6 84 A6 DA B2 32 78
[=] Card has at least 2 application areas. AA1 limit 18 (0x12) AA2 limit 31 (0x1F)
.
[!!] failed to communicate with card
[usb] pm3 -->
Please see the ver of the PM3
[usb] pm3 --> hw ver
[ Proxmark3 RFID instrument ]
[ CLIENT ]
client: RRG/Iceman/master/v4.13441-725-g49ccd6ae1 2021-08-17 10:46:50
compiled with MinGW-w64 10.3.0 OS:Windows (64b) ARCH:x86_64
[ PROXMARK3 ]
firmware.................. PM3 GENERIC
[ ARM ]
bootrom: RRG/Iceman/master/v4.13441-725-g49ccd6ae1 2021-08-17 10:46:37
os: RRG/Iceman/master/v4.13441-725-g49ccd6ae1 2021-08-17 10:46:45
compiled with GCC 10.1.0
[ FPGA ]
LF image built for 2s30vq100 on 2020-07-08 at 23:08:07
HF image built for 2s30vq100 on 2020-07-08 at 23:08:19
HF FeliCa image built for 2s30vq100 on 2020-07-08 at 23:08:30
[ Hardware ]
--= uC: AT91SAM7S512 Rev B
--= Embedded Processor: ARM7TDMI
--= Internal SRAM size: 64K bytes
--= Architecture identifier: AT91SAM7Sxx Series
--= Embedded flash memory 512K bytes ( 53% used )
[usb] pm3 -->
Any help with the iclass cloning instruction will be great. Thanks
Wrong repo.
You are obviously using the RRG software. Please post your issues in the respective github repository https://github.com/RfidResearchGroup/proxmark3
You are obviously using the RRG software. Please post your issues in the respective github repository https://github.com/RfidResearchGroup/proxmark3
Hi pwpiwi
please advise where I should post. Thanks