Need instance name in "Selected Layers"

[BrianOBlanton]

In this example, the two instances differ in the usual metadata by ONLY the instance name; ncsc123_gfs vs. ncsc123_gfs_da in this case. Also not clear if the instance name is correctly being set in the Control Panel when switching between the two in the mapping UI.

[PhillipsOwen]

note: the information listed changes when looking at synoptic and/or tropical runs.

there are a number of places where the model run information is listed. should there be an effort here to standardize?

• the selected model run tray
• the compare layers tray and map surface popup.
• the model selection tray

finally, i am not seeing a disconnect between instance names and gird labels between the selected layers and control panel.

here is a "selected layer" tray example of when the instance name is added for both synoptic and tropical runs. is this acceptable?

[PhillipsOwen]

i refactored the code that the various components use to gather model run details into a common function. this should make it easier to make alterations and keep them in sync.