Possible pause issue

[blueeagle69]

I have noticed that if I pause my 3D printer using the LCD, the light goes out on the Resumer and no-longer does it's slow reading gcode flash when I resume. It appears to be completely dead.
At the end of the print, the +- buttons light up blue and the OK button illuminates red as normal.
Will have to do more testing.

I am running an Anet A8 (stock board) with the latest 1.1.9 Marlin firmware.
I am also running the latest Resumer 3D firmware.
Another thing I have noticed too, is after the print has completed and I press all three buttons to clear the Resumer3D's memory, the OK light flashes quickly and will not re-connect to the printer.
The only way to get it to connect is to power cycle the printer.

Don't know if this is my printer or the Resumer.
Very strange.

[hackaday3D]

@blueeagle69 thanks for comment!
resumer send gcode command M114 to printer while ok blue light up，after receive the return information or timeout the blue light down. if the printer was paused, the printer will not return any information to resumer, so the timeout case the slow light flash, that is normal.

if you have any problem while using resumer, you can catch the log from boxtool.exe, and send to us or comment here.