OctoPrint
Opened this issue · 2 comments
maxlinux2000 commented
Hello,
I use "octoprint" to print.
On my laptop I have CURA, connected wia wifi to octorpint in an orange pi pc, which is connected by usb to the printer (a clone of prusa i3 with gt2560 card).
I was thinking about putting the Resumer3D between the orange Pi and the printer, and putting an SD card in the printer.
In the manual I seem to understand that this can not be done. Is there any way to continue using the octoprint?
regards
MaX
hackaday3D commented
hello,the latest resumer3D firmware support this case of putting resumer between octopi and printer. the resumer3D can pass through all the data between octopi and printer
cinealfa commented
maybe you can update the manual?