Suggestion: have script skip painting over the infill

Question

Suggestion: have script skip painting over the infill

Opened this issue 3 years ago · 5 comments

christopherjamesmeyers commented 3 years ago

I've noticed the script spends a lot of time painting over infill that wouldn't normally be seen and causes issues with layer adhesion (perhaps not letting the ink dry)

Answer 1 · 2021-09-14T13:09:44.000Z

Normally it should only paint the walls. Can you send me a photo of the infill painting?

Answer 2 · 2021-09-25T21:31:06.000Z

Realized I was only looking at the first few layers before it started the infill. however, there is still the issue of layer adhesion

Answer 3 · 2021-09-25T21:46:02.000Z

I didn't have any issues with my basic multi-color prints and layer adhesion. Do you have any issues when doing non-multi-color prints ? Perhaps you don't have your bed close enough and thus not enough "squish" between layers.

Answer 4 · 2021-09-25T21:47:45.000Z

What is your top/bottom speed?

Answer 5 · 2021-09-26T01:19:16.000Z

@csanii123 regular prints work just fine
@Sakati84 15 mm/s, but i have tried halving it as ive seen suggested with no success, as well as halving the Vmax Z from the 25 suggested in the setup