Does not count with interrupt
Closed this issue · 3 comments
kuzmanzs commented
I am using wemos mini and it does not counts from the detector.
I have checked via simple wire if I put to gnd it was counted.
Detector board looks like fine, It makes counting noise and blinking led. But via P3 VIN does not sense anyting. Should I do some modification on the detector board??
kuzmanzs commented
Yes, it has caused the build in pull up resistor for I2C
123LY321 commented
hi
Sorry to disturb you, I want to use STM32 instead of MCU in this circuit diagram. Do I need to change any hardware? After I design according to the circuit diagram, STM32 can't enter interruption and read data, which is similar to your question. Is it convenient to say where you were originally?
I look forward to your reply. Thank you.