Error on compiling

[roccomaster84]

Hello everybody
I got an error on compiling the firmware and I dont know what to do. Maybe anybody can help me.
This si the error I got:

In file included from C:\Users\Danny\Documents\Arduino\libraries\TFT_eSPI\TFT_eSPI.cpp:4595:0:
C:\Users\Danny\Documents\Arduino\libraries\TFT_eSPI\Extensions/Touch.cpp: In member function 'void TFT_eSPI::begin_touch_read_write()':
C:\Users\Danny\Documents\Arduino\libraries\TFT_eSPI\Extensions/Touch.cpp:22:34: error: 'spi' was not declared in this scope
if (locked) {locked = false; spi.beginTransaction(SPISettings(SPI_TOUCH_FREQUENCY, MSBFIRST, SPI_MODE0));}
^
C:\Users\Danny\Documents\Arduino\libraries\TFT_eSPI\Extensions/Touch.cpp: In member function 'void TFT_eSPI::end_touch_read_write()':
C:\Users\Danny\Documents\Arduino\libraries\TFT_eSPI\Extensions/Touch.cpp:37:54: error: 'spi' was not declared in this scope
if(!inTransaction) {if (!locked) {locked = true; spi.endTransaction();}}
^
C:\Users\Danny\Documents\Arduino\libraries\TFT_eSPI\Extensions/Touch.cpp: In member function 'uint8_t TFT_eSPI::getTouchRaw(uint16_t*, uint16_t*)':
C:\Users\Danny\Documents\Arduino\libraries\TFT_eSPI\Extensions/Touch.cpp:61:3: error: 'spi' was not declared in this scope
spi.transfer(0xd0); // Start new YP conversion
^
C:\Users\Danny\Documents\Arduino\libraries\TFT_eSPI\Extensions/Touch.cpp: In member function 'uint16_t TFT_eSPI::getTouchRawZ()':
C:\Users\Danny\Documents\Arduino\libraries\TFT_eSPI\Extensions/Touch.cpp:104:3: error: 'spi' was not declared in this scope
spi.transfer(0xb0); // Start new Z1 conversion
^
Mehrere Bibliotheken wurden für "WiFi.h" gefunden
Benutzt: C:\Users\Danny\AppData\Local\Arduino15\packages\esp32\hardware\esp32\1.0.6\libraries\WiFi
Nicht benutzt: C:\Arduino\libraries\WiFi
exit status 1
Fehler beim Kompilieren für das Board ESP32 Dev Module.

And how is possible to erase the SPIFFS Partition to load other clocks? Because Arduino IDE says that the Filesystem is full.

Are there any solutions for this error?

[tomac01]

Du musst die v1.0.6 vom esp32 Board installieren. Dann sollte es funktionieren.