Display attaching failed
Opened this issue · 3 comments
I think i have the display attaching issue, once i call SSD1306_I2CMasterAttachDisplayDefault(&I2CDisplay,
I2CDisplayWidth,
I2CDisplayHeight,
I2CDisplayAddress,
I2CResetPin)
it all goes into a panic here: (default_if_i2c.c:107) ...
E (1524) I2CDefaultWriteBytes: i2c_master_cmd_begin( I2CPortNumber, CommandHandle, pdMS_TO_TICKS( 1000 ) ) != ESP_OK, result: 263
I'm on Wemos Lolin board with onboard 128x64 OLED (0x3C, SDA on 5, SCL on 4).
That error means it's timing out because it cannot communicate with the display.
Since you're using different pins for SCL and SDA you need to change it from their defaults.
When you make menuconfig you should be able to find TarableSSD1306 under components and in there you can change the default pins for SCL and SDA.
That's exactly what i did actually and it is still dead... Although screen does inits with samples i took from https://github.com/TaraHoleInIt/ssd1306-esp32-idf-testing and i can put some text on...
Hm.
I've just tried it with an esp32thing with SDA on 5 and SCL on 4 and it worked on the first try.
I don't see why it's timing out since both communications functions between code look pretty close, although ssd1306-esp32-idf-testing does no real error checking.
It shouldn't be hanging though, its set up to raise an error but not an abort when such events occur.
This is a bit of a headscratcher though, and might be a bit difficult since I don't have that same board.
Are all of the examples failing the same way?
It might be related to this but I'm not sure: https://www.esp32.com/viewtopic.php?t=6203