UBL100 fails after point 90

Question

UBL100 fails after point 90

Closed this issue a year ago · 10 comments

UBL100 fails after point 90 every time, tried M501 M502, power cycling and repeating, checked the manual leveling.
Pronterface gives nothing but Mesh calibration failed.
It worked first time with no issue, no other SW changes done since then.

Answer 1 · 2023-08-14T10:10:45.000Z

For now i cant reproduce.

Did you any modifications with a terminal?

Answer 2 · 2023-08-14T10:39:10.000Z

second run also was successfull. so most probably not a firmware problem.

Answer 3 · 2023-08-14T11:14:10.000Z

Just a no Y offset probe mount, maybe this could influence?

Answer 4 · 2023-08-14T12:37:58.000Z

yes. thats it. it wont work reliable with a 0 y offset mod.

Answer 5 · 2023-08-14T12:39:38.000Z

Show me your M503 please.

Answer 6 · 2023-08-14T12:47:32.000Z

I'm not near my printer rn but the offset is X46.5 Y0 that's what I changed in the config. I'll install the stock CR mount later and redo the meshing.

Answer 7 · 2023-08-14T12:48:54.000Z

I have this on my todo. But it is a bigger thing to make the probing margins "on runtime" manipulable.

So it will take some versions till it it will be fully supported.

Answer 8 · 2023-09-11T05:41:56.000Z

FYI 7x7 ubl also fails with 0 offset mod

Answer 9 · 2023-09-11T06:06:55.000Z

FYI 7x7 ubl also fails with 0 offset mod

maybe. but its not supported. so i wont invest any time in it. sorry.

Answer 10 · 2023-11-03T21:57:40.000Z

please try the v016 builds.

i have introduced dynamic margins and mesh switch to ubl also now.

https://github.com/ThomasToka/MarlinFirmware/releases/tag/MARLIN-E3S1PROFORK-BYTT-v016