Program Stalling On Use
Opened this issue · 1 comments
Hey, there. This probably won't be seen, but I'll post anyway.
I'm using the official GameCube > Wii U adapter, and have built the program without errors.
With the adapter and controller plugged in, I start the tool up, and it simply stalls (no text). Previously it would at least state that the controller couldn't be detected, I believe? But now, even without the adapter plugged in it stalls. Interestingly, I have to press Ctrl+C twice to get it to quit. If I unplug the adapter, it says the adapter was connected, and then immediately disconnected. modprobe uinput doesn't help with this issue, though I do have to use it to get the program to run once.
Running Solus 1.2.1, 64-bit.
I recommend you apply strace and gdb to investigate further