UART cable solder

[ColdBeer72]

Hi!
In your page you say it's obsolete to desolder the resistors, but pictures show there is no resistor yet in the board...
I suppose those are pictures with older method used.
Do you mean I could directly solder the cable right in the upper side of the resistors (towards the drivers)?

[Tombraider2006]

you are god damn right, the pictures show the old method

[ColdBeer72]

Oh thanks!
So, it's really secure to solder the cable directly in the resistor (driver's side), isn't it?

[Tombraider2006]

yes, this has already been tested by several users, everything works. it also eliminates the risk of breaking the track when soldering

[Tombraider2006]

be sure to use hot melt adhesive to avoid breaking the wire from vibration during future operation of the printer.

[ColdBeer72]

But it's not clear to me if I should solder the cable in the green or red side of the resistor.

Thanks a lot for your clarifications

[Tombraider2006]

green side of course.

[ColdBeer72]

Thanks again for the clarification