Magnet test block v0.1.0
Closed this issue · 1 comments
Vlek commented
This is updated with additional tolerance. I added another 0.15mm on top of already 0.20mm.
I believe that it might have to do with the direction, x or y, that the item is being printed. I wonder if I rotate it, if I would get different results.
However, this is how I will be printing the lunar Vs, so I am going to leave it this way for practicality.
Vlek commented
This printed alright. A little better than the first as I had added brim so that removed a lot of the bowing from the base.
The slots were just right, but I need some wiggle room I feel so I will print another with about half a millimeter of extra space for both. Neither was really better or worse than the other in terms of snugness, they were both fairly snug.