alexreinert/piVCCU

After update of pivccu-modules-dkms 1.0.71 module not found

bbr111 opened this issue · 8 comments

bbr111 commented

After update of pivccu-modules-dkms 1.0.71 module not found

piVCCU version: 3.61.7-67
Kernel modules: Available
Raw UART dev: Not available
Rasp.Pi UART: Assigned to GPIO pins
HMRF Hardware: unknown
HMIP Hardware: unknown
State: RUNNING
PID: 3386
IP: 192.168.30.2
Link: vethpivccu
TX bytes: 31.00 KiB
RX bytes: 26.60 KiB
Total bytes: 57.60 KiB

HM-MOD-RPI-PCB is installed. Systemhare is running for 1 yesr in this configuration.
no changes made to hardware.

How to debug?

alexreinert commented

Closed?

bbr111 commented

@alexreinert sorry for closing to fast. was too late for me to examine the problem. and found a quick solution that worked for short.

Reopening with correct infos about the issue, which I can now also reproduce.

apt/source - testing chanel

after install of pivccu-modules-dkms 1.0.71

piVCCU version: 3.61.7-67
Kernel modules: Available
Raw UART dev: Not available
Rasp.Pi UART: Assigned to GPIO pins
HMRF Hardware: unknown
HMIP Hardware: unknown
State: RUNNING
PID: 3386
IP: 192.168.30.2
Link: vethpivccu
TX bytes: 31.00 KiB
RX bytes: 26.60 KiB
Total bytes: 57.60 KiB

Rollback to version 1.0.70

piVCCU version: 3.61.7-67
Kernel modules: Available
Raw UART dev: Available
Rasp.Pi UART: Assigned to GPIO pins
HMRF Hardware: HM-MOD-RPI-PCB
Connected via: GPIO (/dev/raw-uart)
Board serial: OEQ030xxxx
Radio MAC: 0x58xxxx
HMIP Hardware: HM-MOD-RPI-PCB
Connected via: GPIO (/dev/raw-uart)
SGTIN: 3014F711A061xxxxxxxxx
Radio MAC: 0xB3xxxx
State: RUNNING
PID: 1563
IP: 192.168.30.2
Link: vethpivccu
TX bytes: 6.48 KiB
RX bytes: 9.77 KiB
Total bytes: 16.25 KiB

system is an raspberrypi 4 with bullseye and kernel 5.10.63-v7l+

massa007 commented

Same issue here!

alexreinert commented

Did you reboot after the installation of the new package? If yes: can you provide the output of sudo dpkg-reconfigure pivccu-modules-dkms? If there is a log file referenced, please provide the output of this file, too.

bbr111 commented

install with apt upgrade
reboot
after reboot
pivccu-info
piVCCU version: 3.61.7-67
Kernel modules: Available
Raw UART dev: Not available
Rasp.Pi UART: Assigned to GPIO pins
HMRF Hardware: unknown
HMIP Hardware: unknown
State: RUNNING
PID: 1370
IP: 192.168.30.2
Link: vethpivccu
TX bytes: 7.27 KiB
RX bytes: 11.44 KiB
Total bytes: 18.71 KiB

dpkg-reconfigure pivccu-modules-dkms
Removed /etc/systemd/system/multi-user.target.wants/pivccu-dkms.service.
Removed /etc/systemd/system/pivccu.service.requires/pivccu-dkms.service.
Removed /etc/systemd/system/debmatic.service.wants/pivccu-dkms.service.

-------- Uninstall Beginning --------
Module: pivccu
Version: 1.0.71
Kernel: 5.10.63-v7l+ (armv7l)

Status: Before uninstall, this module version was ACTIVE on this kernel.

dummy_rx8130.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

dw_apb_raw_uart.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

eq3_char_loop.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

fake_hmrf.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

generic_raw_uart.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

hb_rf_eth.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

hb_rf_usb-2.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

hb_rf_usb.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

led_trigger_timer.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

meson_raw_uart.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

pl011_raw_uart.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

plat_eq3ccu2.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

rpi_rf_mod_led.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

rtc-rx8130.ko:

  • Uninstallation
    • Deleting from: /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/
  • Original module
    • No original module was found for this module on this kernel.
    • Use the dkms install command to reinstall any previous module version.

depmod......

DKMS: uninstall completed.

Deleting module version: 1.0.71
completely from the DKMS tree.

Done.
Error! The module/version combo: pivccu-1.0.71
is not located in the DKMS tree.

Creating symlink /var/lib/dkms/pivccu/1.0.71/source ->
/usr/src/pivccu-1.0.71

DKMS: add completed.

Kernel preparation unnecessary for this kernel. Skipping...

Building module:
cleaning build area...
make -j4 KERNELRELEASE=5.10.63-v7l+ ARCH=arm all......
cleaning build area...

DKMS: build completed.

dummy_rx8130.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

dw_apb_raw_uart.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

eq3_char_loop.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

fake_hmrf.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

generic_raw_uart.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

hb_rf_eth.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

hb_rf_usb-2.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

hb_rf_usb.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

led_trigger_timer.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

meson_raw_uart.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

pl011_raw_uart.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

plat_eq3ccu2.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

rpi_rf_mod_led.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

rtc-rx8130.ko:
Running module version sanity check.

  • Original module
    • No original module exists within this kernel
  • Installation
    • Installing to /lib/modules/5.10.63-v7l+/kernel/drivers/pivccu/

depmod.....

DKMS: install completed.
Created symlink /etc/systemd/system/multi-user.target.wants/pivccu-dkms.service → /lib/systemd/system/pivccu-dkms.service.
Created symlink /etc/systemd/system/debmatic.service.wants/pivccu-dkms.service → /lib/systemd/system/pivccu-dkms.service.
Created symlink /etc/systemd/system/pivccu.service.requires/pivccu-dkms.service → /lib/systemd/system/pivccu-dkms.service.

no log file referenced found.

alexreinert commented

Please retry using the latest update.

bbr111 commented

Works for me.

dampflok2000 commented

Hi,

after a new installation of Raspberry Pi Os Lite (Bullseye -> tested on 32- and 64-bit) I have the same error when I try to manually install pivccu3. Is there a workaround available?

Best regards
dampflok2000