Combination not working pivccu3 / CUXd / ioBroker /zigbee / USB-Dongle CC2531 - solved
melzerto opened this issue · 4 comments
piVCCU 3.67.10.77, Cux-Daemon 2.9.4
After installing the adapter zegbee.0 and configuring the USB-Dongle to /dev/ttyACM0 with TI Z-Stack/CCxxxx The adapter is going to error with log-entry
error: zigbee.0 (19252) Error: Failed to connect to the adapter (Error: SRSP - SYS - ping after 6000ms)
Reason:
The LXC container will grab the ttyACM0 and provide it to Cux-Daemon.
The Cux-Daemon will connect to ttyACM0 and show this port as available at the status page. According to the Cuxd_2.10 manual this is a default behaivor.
Solution:
Disable this port by adding TTYASSIGN=ttyACM0:NC in the setup page (cuxd.ini)
In the status page should be then shown
Kein TTY-Device connected!
I do not understand your issue. You assign an USB device to the CCU container and complain about the container using it?
Just do not assign it to the container.
The issue is that I dont want to assign the USB port to the LXC container. It does it by default itself including that Cuxd open the port without any use for it. The more clean way would be of course to block the assignement in the /etc/pivccu3/lxc.config or elsewhere. That could be your final proposed solution.
And this is already implemented, see the Readme.
Confirmed. After executing sudo dpkg-reconfigure pivccu3 threre will be the option not to use ttyACM0 device.
Thank you for hint