piVCCU does not detect HM-RFUSB
kornet9m133 opened this issue · 1 comments
Hi,
I created SD card with clean image RaspberryPiOS_lite_piVCCU3_2020-12-07.img and started on RPI4 with new HM-RFUSB stick.
After boot I get
root@raspberrypi:/home/pi# pivccu-info
piVCCU version: 3.53.34-50
Kernel modules: Available
Raw UART dev: Available
Rasp.Pi UART: Assigned to GPIO pins
HMRF Hardware: unknown
Board serial: unknown
Radio MAC: unknown
HMIP Hardware: unknown
SGTIN: unknown
Radio MAC: unknown
State: STOPPED
dmesg also shows the usb stick
[ 73.542507] usb 1-1.1: new full-speed USB device number 4 using xhci_hcd
[ 73.677648] usb 1-1.1: New USB device found, idVendor=1b1f, idProduct=c020, bcdDevice= 1.00
[ 73.677656] usb 1-1.1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 73.677663] usb 1-1.1: Product: eQ-3 HmIP-RFUSB
[ 73.677670] usb 1-1.1: Manufacturer: Silicon Labs
[ 73.677676] usb 1-1.1: SerialNumber: 3014F711A0000420C9A1799B
To verify that the HM-RFUSB is working I tried RaspberryMatic-3.69.7.20230626-rpi4 and it is detected and works fine.
Do I need to change some config for piVCCU ? What could be the problem ?
Any help is very welcome, thank you.
sorry, did not see the section on how to reconfigure for radio module: dpkg-reconfigure pivccu3
now it works