[BUG] Always in MANU Mode
Opened this issue · 3 comments
Describe the bug
A clear and concise description of what the bug is.
Start the RPiZ2 with only power connected and goes into MAU Mode.
even with the created file /root/.pwnagotchi-auto which is suggested on the website.
To Reproduce
Steps to reproduce the behavior:
- just connect the 5V power
Expected behavior
A clear and concise description of what you expected to happen.
Should goto AI-Mode
Screenshots
If applicable, add screenshots to help explain your problem.
Environment (please complete the following information):
- Pwnagotchi version 1.8.4
- OS version included in .18.4
- Type of hardware Raspberry Pi Zero 2 W
- Any additional hardware used 12V/3,6AH Akku, Step-Down-Converter to 5Volts, a Switch to switch on/off
Additional context
Add any other context about the problem here.
Uncommented configs are very Configuration parameters that are described extremely poorly or not at all properly don't really make the whole project any easier. No matter how much knowledge you have of the matter, if the settings are not described, what exactly they do and what they are there for and you have to figure it all out, you will end up with non-functioning software.
Your config file is likely not set up correctly. If you only use the skeleton config file, it won't do much.
I have a similar behaviour on a Raspi 3. The qenagotchi works and I see collected handshakes, when I start it "headless". I even see it as a peer on another pwnagotchi. But when I create the /root/.pwnagotchi-auto file and restart or "Restart into AI mode" from the webinterface it doesn't take long to show the following in the log:
[2024-02-15 15:33:07,530] [INFO] entering manual mode ...
And I'm back to manual. I'm running Pwnagotchi version 1.8.5