3.5.1.4 ipv6 settings should be configured either way

[zac90]

Describe the Issue
Currently the ipv6 settings are only configured if ipv6 is declared in use. I think they should be set either way as auditing tools might throw an error if it isn't configured even if ipv6 isn't in use. It also prevents ipv6 being enabled in the future but this control not being changed.

      - name: "3.5.1.4 | PATCH | Ensure loopback traffic is configured | Set deny ufw rules IPv6"
        community.general.ufw:
            rule: deny
            direction: in
            from_ip: '::1'
        notify: Reload ufw
        when: ubtu22cis_ipv6_required

Expected Behavior
ipv6 settings not being configured unless explicitly stated that ipv6 is in use.

Actual Behavior
ipv6 settings only run if the ubtu22cis_ipv6_required is true

Control(s) Affected
3.5.1.4

Possible Solution
Remove the conditional when: ubtu22cis_ipv6_required