Tools->Mode->Debug appears to be stuck on

[KurtE]

I tried it out for a while on my first GIGA board. To see what all I could do with the
debug monitor, with a working sketch.

It now appears to be permanently in that mode. That is no matter what zephyr sketch I install, it will always
just show a prompt at the uart:~$
And wait for me to type sketch

Note: I have downloaded many versions of the firmware to this board. I have run it on both Windows and Ubuntu and I have down clean downloads, bootstrap and builds of the ArduinoCore-zephyr code base.

Also my other Giga, does not require me to enter something, at the prompt, unless there is a problem.

[KurtE]

@facchinm @pillo79 - Note: I am still having this issue. That maybe on both of my GIGA boards, I have to have debug monitor open and type: sketch to get it up and running, regardless of the state of Debug/Standard

Any ideas on how to reset this?

[pillo79]

Will publish a major update soon on this!