bangerth/helmholtz

Issues

• Make sure we write to the common output files under a mutex.

  #35 opened 2 years ago
  1

• Flag that determines that we only want diagnostic output, no solution

  #34 opened 2 years ago
  2

• Output boundary indicators and areas

  #33 opened 2 years ago
  1

• Complete point value output for the with-attenuation case.

  #32 opened 3 years ago
  1

• Concatenate all .csv files into one

  #31 opened 3 years ago
  1

• Figure out whether the solution for the test case should/should not be symmetric

  #30 opened 3 years ago
  1

• Standardize writing complex numbers as a+bj

  #29 opened 3 years ago
  1

• Add a table of contents to the readme.md file

  #28 opened 3 years ago
  1

• Also write output data into a CSV file

  #27 opened 3 years ago
  1

• Document CSV output file

  #26 opened 3 years ago
  1

• Finish documenting point values in the example section

  #25 opened 3 years ago
  1

• Finish documenting the plain text output files

  #24 opened 3 years ago
  1

• Reverse the order of indices in the U, P, and M matrices

  #23 opened 3 years ago
  1

• Milestone 2: Read COMSOL files

  #22 opened 3 years ago
  1

• Document the surface output in the readme.md file

  #21 opened 3 years ago
  1

• Move surface output into visualization/ folder

  #20 opened 3 years ago
  1

• Visualize boundary indicators

  #19 opened 3 years ago
  1

• Validate the correctness of results for the 5cm cylinder

  #18 opened 3 years ago
  1

• Milestone 2: Standardize and document error reporting

  #17 opened 3 years ago
  1

• Milestone 1: Name output files by the number of the frequency

  #16 opened 3 years ago
  1

• Signal failure

  #15 opened 3 years ago
  1

• Milestone 1: Create success file

  #14 opened 3 years ago
  1

• Milestone 2: Use file prefix

  #13 opened 3 years ago
  1

• Milestone 2: Write each frequency results into its own files

  #12 opened 3 years ago
  2

• Milestone 1: Update readme.md for the new frequency-dependent stuff

  #11 opened 3 years ago
  1

• Milestone 2: Implement the mesh refinement criterion

  #10 opened 2 years ago
  3

• Milestone 1: Implement frequency-dependent density and bulk modulus

  #9 opened 3 years ago
  2

• Fix check_for_termination

  #8 opened 3 years ago
  1

• Milestone 2: Fix the output format of the P and U matrices

  #7 opened 3 years ago
  2

• Milestone 1: Output pressure and velocity at "listening points"

  #6 opened 3 years ago
  1

• Milestone 1: Verify correctness of the code

  #5 opened 3 years ago
  2

• Milestone 1: Write the initial version of the manual/readme.md file

  #4 opened 3 years ago
  1

• Milestone 1: Correct the definition of the velocity on ports during postprocessing

  #3 opened 3 years ago
  2

• Milestone 1: Correct the boundary conditions on the output ports

  #2 opened 3 years ago
  2

• Milestone 1: Implement a way to scale STL geometry to SI units

  #1 opened 3 years ago
  2