How to connect DC-DC Modul with all 8 Pins?
dk83 opened this issue · 1 comments
dk83 commented
Hello,
I would like to connect the DC-DC module to the board in order to have enough power for 0.5m Neopixel Led and a Raspberrypi 3.
One side of the module goes into the 4-pin Vin connector, but with what do I connect the other 4-pins of the DC-DC module?
In the description of other SKR boards, all 8 pins of the DC-DC module are connected, but the drawing for the module is missing for the skr e3 turbo...
dk83 commented
Solved for me:
The Bigtreetech DC - DC Modul V1.0 is to short for this board.
- Vout is not explaned in pinout diagramm. This is the 4 Pins over the Jumper.
- Set the Jumper for use with "Bigtreetech DCDC 5V V1.0 module"
- Be careful, the right pin of the Vout connection is ground, the left pin is 5V.
